repmgr daemon start

repmgr daemon start — Start the repmgrd daemon on the local node

Description

This command starts the repmgrd service on the local node.

By default, repmgr will wait for up to 15 seconds to confirm that repmgrd started. This behaviour can be overridden by specifying a different value using the --wait option, or disabled altogether with the --no-wait option.

Important

The repmgr.conf parameter repmgrd_service_start_command must be set for repmgr daemon start to work; see section repmgr daemon start configuration for details.

Options

--dry-run

Check prerequisites but don't actually attempt to start repmgrd.

This action will output the command which would be executed.

-w
--wait

Wait for the specified number of seconds to confirm that repmgrd started successfully.

Note that providing --wait=0 is the equivalent of --no-wait.

--no-wait

Don't wait to confirm that repmgrd started successfully.

This is equivalent to providing --wait=0.

Configuration file settings

The following parameter in repmgr.conf is relevant to repmgr daemon start:

repmgrd_service_start_command

repmgr daemon start will execute the command defined by the repmgrd_service_start_command parameter in repmgr.conf. This must be set to a shell command which will start repmgrd; if repmgr was installed from a package, this will be the service command defined by the package. For more details see Appendix: repmgr package details.

Important

If repmgr was installed from a system package, and you do not configure repmgrd_service_start_command to an appropriate service command, this may result in the system becoming confused about the state of the repmgrd service; this is particularly the case with systemd.

Exit codes

One of the following exit codes will be emitted by repmgr daemon start:

SUCCESS (0)

The repmgrd start command (defined in repmgrd_service_start_command) was successfully executed.

If the --wait option was provided, repmgr will confirm that repmgrd has actually started up.

ERR_BAD_CONFIG (1)

repmgrd_service_start_command is not defined in repmgr.conf.

ERR_DB_CONN (6)

repmgr was unable to connect to the local PostgreSQL node.

PostgreSQL must be running before repmgrd can be started. Additionally, unless the --no-wait option was provided, repmgr needs to be able to connect to the local PostgreSQL node to determine the state of repmgrd.

ERR_REPMGRD_SERVICE (27)

The repmgrd start command (defined in repmgrd_service_start_command) was not successfully executed.

This can also mean that repmgr was unable to confirm whether repmgrd successfully started (unless the --no-wait option was provided).

See also

repmgr daemon stop, repmgrd daemon, repmgr service status, repmgr service pause, repmgr service unpause